RUST CONVERTER PRIMER
PRODUCT FEATURES
- Specially formulated product for use as a
- Converts rust into a corrosion resistant coating while providing excellent adhesion to the subsequent application of primers and topcoats
- Eliminates the need for sanding on areas difficult
to reach
- Eco-friendly product
Surface Preparation
The surface to be treated should be free of grease, dirt, loose paint
and scaling rust. Light wire brushing may be required.
Mixing and Thinning
GS 202 is a one component product and must be applied as is.
Dilution of the product with a solvent or thinner is not recommended.
GS 202 must be applied at room temperature.
Application
Allow to dry and set for 24 to 48 hours. to permit the coating to
harden while converting the rust.
NOTE: Keep coated articles protected form rain during the 24-48
hours set period. Should the surface be wetted during this period,
the product will have to be reapplied.
After the 48 hours period, rinse surface with water and allow to dry
thouroughly before painting.
Application Conditions
Industry standards are for the substrate temperatures to be above
10º C of the dew point. Condensation due to substrate temperatures
below the dew point can cause flash rusting on prepared steel and
interfere with proper adhesion to the substrate.
Special application techniques may be required above or below
normal application conditions.
| Condition |
Material |
Surface |
Ambient |
Humidity |
| Normal |
60 - 85º F (16 - 29º C) |
60 - 85º F (16 - 29º C) |
60 - 90º F (16 - 32º C) |
0 - 65% |
| Minimum |
50º F (10º C) |
50º F (10º C) |
50º F (10º C) |
0% |
| Maximum |
90º F (32º C) |
100º F (35.5º C) |
100º F (35.5º C) |
85% |
DISCLAIMER: All information is given in good faith. Since conditions of use are beyond the manufacturer's
controls, all information contained herein is without warranty, implied or otherwise. All technical data and
specifications are subject to change. Please consult with your Glass Shield representative for more detailed
coating recommendations. Revised 08-01-2007
Technical Data
| Appearance |
Green liquid |
| Specific density |
1.185 g/ml @ 25ºC |
| Bulk density |
12 lb / gal |
| Rinsing |
None |
| Concentration |
Use as is |
| Temperature |
Room |
| pH |
1 |
| Cure times |
24-48 hours |
| Application |
Spray-on, brush or wipe-on |
Precautions
GS 202 is a highly acidic product that may cause burns to the skin
and eyes. Personnel using this product should wear safety goggles,
rubber gloves and other suitable protective clothing when handling.
Avoid all contact with skin and eyes. Keep container closed when not
using this product. Store in a cool, dry area away from strong oxiding
materials.
In doubt? Contact technical services at 1-800-361-6652 for proper
guidance in preparing substrate
